baok Posted May 30, 2013 Report Posted May 30, 2013 I’ve read quite a bit (and watched videos) on the subject of how you stand and use your body when hand-planing. Conventional wisdom has you stand more or less behind the stock and push the plane. But I swear that I have more fun with it (and sweat less) by standing beside the stock and scooting the plane sideways. I suppose it doesn’t matter as long as the work gets smoother and/or straighter. Mind you, this doesn’t really work when I try to edge-joint long boards but no one technique is good for everything. Quote
Tom Crawford Posted May 31, 2013 Report Posted May 31, 2013 I tend to use the stand beside more than stand behind. I also occasionally use a 'Japanese' stand behind and pull. Quote
jhl.verona Posted May 31, 2013 Report Posted May 31, 2013 When I need very fine control of the plane and the piece is not too long, then I find that I get better results by locking my arms and using my legs. I try to do this when smoothing or jointing - take a look at David Charlesworth 'in action' to see what I mean. I stand just behind the board, weight on my back leg, then move my weight forward onto my front leg - I keep my legs about 80cm - 36" apart. I can do this on boards up to about 24" - 60cm. Anything longer, and I'll extend my arms at the end, because I only need forward pressure at the end of a cut. On less precise work (or at least because I get less precision) I'll use my arms more. Scrubbing, flattening, thicknessing. I always try to leave myself a bit under 1/2 mm (1/32") for final smoothing. Sometimes the board is just too wide or long for leg work, so I'm forced to extend my arms, but if I also have to outreach (because of the width) I much prefer to pull from the other side or swap hands rather than overstretch myself. I am not of gorilla build, so if I have to face an extended planing session, I give myself plenty of breaks - usually doing other things. There's nothing worse than tired arms or legs to ruin all that hard work, except maybe a dull blade. John Quote
G S Haydon Posted May 31, 2013 Report Posted May 31, 2013 Good recommendation John. David is a very methodical teacher from what I have seen. I caught up with some of his chiseling knowledge on YouTube, very detailed. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.