Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Problematic Organ Bench

Featured Replies

Shellac is not a very durable finish.  Poly is going to be much tougher.  The more coats, the tougher it will be.  Five should be adequate, ten would be overkill.  If you use gloss poly and rub out the finish to a very high grit, it's going to be slick as glass.  You have to wait for any finish to cure.  Give it at least several days before you start rubbing it out...several weeks is better.

I'd take it down to bare wood, and coat it with Moisture Cure Urethane floor finish. You can get gloss or satin.  It would have to be finished in a well ventilated place, though because the stuff outgasses large amounts of Tolulene and Xylene really quickly. Wear an organic vapors respirator.  A couple of coats of that stuff, and it could be tap danced on with no damage.  I have it on floors I've finished since the mid 1970s, and not a single one has needed to be refinished.

 

I'd do it for you if you were anywhere near me.  It's an unforgiving finish to apply.  You get one shot at it. Reluctance will get you into trouble with it.  It dries so fast that you cannot go back over it until it's completely dry.  You put it on with a lambswool mop.  I have wiped it on with a rag on some small pieces, by putting some in a clean and dry waterbottle, and tipping it onto the rag held in a gloved hand.

 

After it's dry, you can go over it with 0000 steel wool and Pledge, and the Sisters may shoot off the other end when they slide on it.

 

Two coats would be enough, with the second coat done the day after the first, and put it into use the next day.

 

If there is a company that sells flooring stuff just to flooring contractors in your town, they will have it.  You can't find it in a regular paint store. There are a bunch of manufacturers that make it.   You can get it online:   http://www.ebay.com/itm/like/290887231730?lpid=82  It's not a "poly" urethane.

A water based poly/ acrylic finish is pretty tough. It also dries fast and fairly odorless. You can sand between coats or buff with an abrasive pad. You can build coats pretty quickly and a cheap foam brush works well.

I would start by sanding off the poly coats for a fresh start.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,009 Total Members
  • 3,644 Most Online
  • Joseph b Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.