CessnaPilotBarry Posted March 17, 2014 Report Posted March 17, 2014 I like lock miters, both to build quadralinear legs with wrap around figure, and for certain exterior projects for the strength. When well cut, they assemble quickly and accurately, and are super strong. I'd use them more often, but at least for me, setup was time consuming, and required a bunch of test cuts using stock planed exactly to the same thickness as the project stock. I've used setup blocks, dial indicators and height gauges, etc... In the end, I had good joints, but it took soooooo long to get there. While web searching for a better way to do this, I stumbled upon a You Tube video about the Infinity Tools Lock Miter Setup Jig, by Chris Adkins, and decided to give it a shot. I followed the instructions, grabbed some sacrificial stock, and gave it a ride.... Here it is, in place for a photo: This device, a CNC machined aluminum plate, with several magnets, doesn't look like much. In fact, it might be a great example of why we shouldn't price our work based on multiples of materials cost. The devil is in the details though, and the jig is precisely machined to mate the center of the profile to the center of whatever stock you're using. In fact, you can easily use different thicknesses of stock interlocked in the same joint, with little extra effort! I used my Tite-Mark to mark the centers on my test boards, then set the fence and bit height to where the jig installed on my Whiteside bit matched my stock. The result? PERFECT lock miters, creating a perfectly square post, on the FIRST attempt! Including reading the instructions, the setup took less than 10 minutes! Here's what showed up a bit later: Assembled, not glued: The end result is four bed posts cut well enough to require nothing more than tape or shrink wrap at glue-up, in just a few minutes of setup. I paid full price for mine at Infinity Tools Full Instructions, and more explanation of the device's operation, are here If you like this joint, but hate the setup, you'll love this device. Quote
Guest Posted March 17, 2014 Report Posted March 17, 2014 impressive. I have never gotten good joinery off my router table but those joints look nice. $29 isn't bad. Quote
dwacker Posted March 18, 2014 Report Posted March 18, 2014 That an expensive substitute for a sharp pencil and ruler. It would be nice if manufacturers would actually supply folks with the proper instructions to use these bits rather than leave them guessing. Guys that cut corrugated knives have been scribing the face of the knife at the center point for decades. Quote
Cochese Posted March 18, 2014 Report Posted March 18, 2014 I like that a lot. If I get into that type of joint I'll know what to grab. Quote
EyeToTheSky Posted March 19, 2014 Report Posted March 19, 2014 Thanks for your fine review, along with where to get it, and U-Tube.. That's a jig that will diffidently be on my wish list. Regards Quote
Rick LoDico Posted March 19, 2014 Report Posted March 19, 2014 I've had that jig for a while now but not the opportunity to try it out. Soon, hopefully. Quote
Alan Bienlein Posted March 19, 2014 Report Posted March 19, 2014 I remember when he first posted his Idea and I went and made one out of phenolic to try out. It worked perfectly the first time I set up the lock miter bit. If I didn't have the ability to make one that is one set up jig thats worth the money! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.