chefmagnus@grics.net Posted November 7, 2014 Report Posted November 7, 2014 Ok I have the motor pulled out of my Unisaw. I borrowed Mitutoyo dial indicator.I had not used a dial indicator since college and am amazed at what the digital ones can do. I placed it on my arbor and got a variance of .005mm and a variance of all 0s on the flange. I checked the fence to the right miter slot and got a variance of .0018mm from front to back. The left mitre slot had a variance of .0016mm Since the top is not on the saw I was not able to check the blade. Will this need to be rechecked when I re-assemble the saw? Also since the motor wasn't in the saw, the belts were off, would this cause an error? Also if I did the measurement right the pulley on the motor is out of round by .0006mm, Is this anything to worry about? Before I took it apart it cut beautifully. Almost no effort to put a piece of 2" purpleheart through ripping it in half. Did I mention that I love my new Mirco Jig G-RRippers. I would have been high in the pucker-o-meter trying to rip something this narrow before... Quote
wdwerker Posted November 7, 2014 Report Posted November 7, 2014 If you can get it back together even close to that I see no reason to futz with it. Belts may make a little difference . New belts might vibrate a little until they get broke in, but my last set performed great for over 20 years. Quote
Tom Cancelleri Posted November 7, 2014 Report Posted November 7, 2014 I would check everything again once everything is reassembled. Just make sure the fence is tapering out a few thousands from the miter slot to help with avoiding kickback Quote
wdwerker Posted November 7, 2014 Report Posted November 7, 2014 Those Micro Jig grippers take a few seconds to set up but they do make cuts safer and cleaner. Quote
Tom Cancelleri Posted November 7, 2014 Report Posted November 7, 2014 I love my Grr-Ripper I use it on every rip cut. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.