Recommended Posts

Posted

I have a sheet of melamine that I got for cheap and thinking of using that for the base for my crosscut sleds. Any reason not to use it? It's slicker than plywood so should slide smoothly but didn't know if it would scratch the cast iron? 

Posted

You'll be fine from the cast iron angle.  I don't like melamine for another reason, it's slippery.   I like the inside of my sled floors to have a bit of traction, to help keep the work in place.   This makes it easier to get perfect single cuts without a stop block.

 

You could use the sheet as a bench protector for glue-ups, the top layer of a router table top, clamp cauls and pads, veneer press plates... 

Posted

Sand and bevel the edges that will be exposed. The sharp corner can cut like a razor. I would seal those edges as well, moisture makes the particleboard core swell. It's pretty stable material for sleds and jigs.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   0 Members, 0 Anonymous, 45 Guests (See full list)

    • There are no registered users currently online
  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined