Recommended Posts

Posted

I'm in the process of buying a 17" Grizzly G0513X2BF band saw and am looking into sources for blades - 131.5" band length.

I'm setting up a new 1 man shop and I don't know how many blades I will even use up. Saw will be used regularly but not all-day every-day type of use. There will be some re-saw use but I'm not milling every single board from tree trunks, etc.

Do you make your own band saw blades? By make' I mean buy coiled blade stock and braze/weld your own custom lengths. If so, where do you buy your supplies (coiled stock, brazing, flux, etc.)?

I've watched several videos on YouTube about brazing the blade joint, etc. but have no welding equipment. On one of the videos a guy used a standard propane torch - anyone with experience to know if this will work properly or does propane burn too 'cold' and/or slow to do a good job?

Basically I'm looking for advice about whether I should just buy finished blades or 'make' my own.

Posted

Not sure how much you would be saving by buying coiled blade. Think of it this way. On a 131.5" blade if you save 5 dollars that would be a lot. By the time you buy the gas and brazing rod your down to 3 dollars a blade if lucky. Now divide how many cuts you get with one blade by 3 dollars. Congrats, you've saved 2 cents per cut. :-)

FWIW Brazing rod goes for around $130. / lb. Those blades from the factory are likely spot welded with very expensive machines that cost pennies to run.

Should you decide to venture into this anyway. You would want accetylene and a turbo tip of the #6 or 7 variety. Or better yet an oxy accetylene set up "burgler outfit" with brazing tips.

Posted

Its the 21st century. The only reason to make your own blades is to save down time. With a small shop and a small 17" bandsaw it completely unnecessary. Buy and extra blade and hang it on the wall, problem solved. You say one man shop, so I assume you mean business. Band stock and supplies is a waste of inventory capital.

Posted

That looks like a nice bandsaw.  Wish i could buy one.  But i already have the smaller Grizzly G0555LX 14" bandsaw.

 

I've have good luck so far with the Highland Woodworking "Wood Slicer" blades.  They sell them in 1/2" and 3/4" widths, and any length you want.  I certainly wouldn't trust myself to weld a good joint that could reliably handle the stress of a bandsaw...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   2 Members, 0 Anonymous, 55 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined