rmartuszewski Posted December 30, 2015 Report Posted December 30, 2015 So the shop I custom paint motorcycles at needed a better money box for selling sodas. So I built this for them. 4/4 walnut, box joints and rabit lid/bottom. With lid/bottom extending out to edge. First time using the rockler box joint jig someone gave me for free. Don't like it, up spiral bits had bunch of tear out on box joints. May try table saw jig (need to build) next time. Bought hasp ad lock that is decorative, haven't been installed yet. 1 Quote
Strasberry Posted December 30, 2015 Report Posted December 30, 2015 I have made dozens of boxes with the rockler jig. I had the same problem with tear out until I used a backer board and changed it often to keep a fresh clean edge to the backer. That took care of about 95% of the tear out. Quote
rmartuszewski Posted December 30, 2015 Author Report Posted December 30, 2015 I put a brand new one on that was oak. Cut, planed, trued up. Still did it, maybe it was speed pushing it through. Maybe it was me, idk. Haven't wrote it off but dados always come out perfect on table saw hence why I may try that way. Maybe just walnut also, may try again with oak or something. Quote
Strasberry Posted December 30, 2015 Report Posted December 30, 2015 I made a few with the table saw and a home made jig. Worked OK but like the ease of use of the Rockler. I haven't made any boxes as big as yours so that may be an issue I haven't encountered yet. All the boxes I make are sold to a local chocolate factory and they sell them with chocolates inside. 1/4" material and joints. Sent from my XT907 using Tapatalk Quote
John Page Posted December 30, 2015 Report Posted December 30, 2015 I had a handful of similar problems with the porter cable jig. After scribing a line on the bottom edge of the box fingers, I had virtually no tearout (still using a backing board). Quote
ColinF Posted January 4, 2016 Report Posted January 4, 2016 Looks great! I'm with Lester, I didn't even see the seam until I looked at the pic after seeing the lid lifted! Very nice work. Quote
shaneymack Posted January 5, 2016 Report Posted January 5, 2016 Box looks great. Ive never used the jig you used but maybe a down cut spiral would give better results? Sent from my SGH-I337M using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.