BobInAustin Posted April 6, 2016 Report Posted April 6, 2016 I bought the JessEm MAster Lift for my router. Fits in the hole I had for my Kreg perfectly except the JessEm needs a lip to rest on. Does anyone have the template (local) or can someone give me the dimensions of the template? I need to make a new table insert it seems. unsure emoticon Quote
trialbyfire Posted April 6, 2016 Report Posted April 6, 2016 If you have lift couldn't you trace it onto so 3/4 ply and cut out the positive or negative of your trace? (which ever one you need) I didn't do this for a lift but I did do it for my Jessem plate. I traced the plate and cut it out on the inside of the plate. I then used the "negative" as a template for a flush trim bit. I don't know it that helps but your situation sounds similar. Quote
gee-dub Posted April 7, 2016 Report Posted April 7, 2016 I'm not quite getting the picture. The fits the width and length and corner radii of the Kreg plate. Do you plane to add material underneath? Can you not use the Kreg levelers or is the JessEm plate too thick? Quote
BobInAustin Posted April 7, 2016 Author Report Posted April 7, 2016 You see how the Kreg insert sits on its own plastic rests that are screwed in from below. If I just set the JessEm in there, the holes to secure it down do not line up. Since it fits in the existing hole, I think I can just use that as the template and route out a 3/4" rabbet on a new table top for the Jessem to sit on. Quote
trialbyfire Posted April 7, 2016 Report Posted April 7, 2016 Are the studs on the table portion the problem? If so can you cut them off? Or can you just drill a new hole where your Kreg brackets are? Quote
gee-dub Posted April 7, 2016 Report Posted April 7, 2016 Ah, I get it now. Thanks. With the right diameter router bit, this will get you dead-on. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.