Popular Post wdwerker Posted December 20, 2016 Popular Post Report Posted December 20, 2016 I spend a lot of time routing laminate with my trim routers. The little chips get everywhere and can cause scratches. The Festool MFK 700 has a shroud that attaches to the base but it allows the chips to escape and the hose gets in the way. I also use a Dewalt trim router to round over the edge after its trimmed flush . So I worked up a shopping list for the hardware store. Needed several sizes of metric screws plus some sort of fitting to route the hose out of the way. I've seen some expensive specialty router bases but they were too big, but I took some ideas from them. A 1 1/4" copper street ell, a rubber coupling and a cheap paint brush re routed the hose and closed the biggest gap chips were escaping from. Festool collection was much improved ! 5 Quote
wdwerker Posted December 20, 2016 Author Report Posted December 20, 2016 I drew out a guard for the Dewalt on some Baltic scraps. Cut them out, drilled for screws and assembled them with some new super glue. You get 3 to 5 minutes to reposition parts and get them in clamps. Then it's completely cured in 30 minutes. Stronger than yellow glue and no moisture to swell wood fibers either. A few micro pins hold things in place then clamps close any tiny gaps. 1 3/8 hole fits the Festool hose , so that's what I drilled in the little triangle pieces. I cleaned up the shapes on my spindle sander after 30 minutes and attached the hose port triangles . I made a clear cover for the bottom from some thin plexiglass . I was going to caption each picture and made some mistake when I uploaded them. I'll polish it off tomorrow and take it for a test run. Quote
wdwerker Posted December 21, 2016 Author Report Posted December 21, 2016 Got it finished today. The paint brush improved the chip collection. I need to get a wider brush. I tried it out and was quite pleased with the results. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.