aazurmendi Posted March 28, 2011 Report Posted March 28, 2011 Hello, always wish I new how to work with wood. Hopefully, will have some time to make things, but first I have to fix stuff in my log house. Bought a table saw, After my 10 cuts, run the tip of my fingers into the blade. Got lucky I have a nice strait in the middle kerf cut ¾ in the nail. Felt pretty stupid and still do... I would like to restart that better the next time(couple of week). Could I get some recommendation on where to take a class so that I learn to use that tool the safe and easy way? Also where does one find some ruff cut wood I would need 1 x 12 x 10' board. I leave in Cartesville Ga. In advance thanks Quote
Sac Posted March 28, 2011 Report Posted March 28, 2011 You can start by watching all of these safety videos. Then, not sure how far you are from Atlanta, but you can head to Highland Woodworking and take the Fundamentals of Woodworking Class. Might be a good place to start.. Quote
Texfire Posted March 28, 2011 Report Posted March 28, 2011 (edited) Without knowing more about the circumstances leading up to your accident, I can only make some general suggestions. Miter gauges/sleds, featherboards and push sticks are all ways to keep your hands from getting too close to the blade. Glad to hear that you weren't seriously injured. *Edited to remove redundant information that Sac posted ahead of me.* Edited March 28, 2011 by Texfire Quote
Beechwood Chip Posted March 28, 2011 Report Posted March 28, 2011 Here's a post I did on table saw safety a while back, that you might find helpful. There's a lot of information out there, and I tried to make a quick, short list of the things I thought were most important. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.