tdale51@yahoo.com Posted December 31, 2011 Report Posted December 31, 2011 This might be a dumb question but here goes...the factory blades in my 6" Rigid jointer are starting to show signs of wear. My question is can they be sharpened? If so would you go about the process similarly to sharpening a chisel or plane iron with sandpaper and float glass? Quote
Nick2cd Posted December 31, 2011 Report Posted December 31, 2011 tdale, i believe you can sharpen them, as there is plenty of metal to do so. however, i would recommend just getting the replacement Freud knives. the only reason i say this is because there is soooo much precision involved in setting up a jointer. if you created a low side or spot (just by a few thousandths) on one or two of the blades, it could make setup a nightmare. the replacements can be purchased through amazon (click the link on the side of thewoodwhisperer.com page so Marc gets credit for the purchase). they cost about $21 last i checked. i have the same jointer and recently posted a thread about changing the knives. it should still be on the first page in the normite city section. have a quick look at it. hope it helps. Quote
Jim Heinbuch Posted December 31, 2011 Report Posted December 31, 2011 While I am a newbie at sharpening, I sent my jointer knives to a commercial sharpener through a local tool store. Quote
Nick2cd Posted December 31, 2011 Report Posted December 31, 2011 here's that knife changing thread http://woodtalkonline.com/topic/5823-just-changed-the-knives-on-my-ridgid-6-jointer/ Quote
tdale51@yahoo.com Posted December 31, 2011 Author Report Posted December 31, 2011 Nick, I had already read your post. It gave me a lot of confidence that I can remove/replace these knives with success. I'd been worried about that since I bought it. Thank you for posting. and you're right, the blades are still $21ish. The Freud knives get mixed reviews on Amazon, what's you're experience. Quote
rmac Posted December 31, 2011 Report Posted December 31, 2011 Here's the other side of the story, in the form of links to two different jigs for sharpening jointer and planer knives using sandpaper http://superwoodworks.com/Projects/JKnifeJig.htm http://www.garagewoodworks.com/video.php?video=v34 -- Russ Quote
Nick2cd Posted December 31, 2011 Report Posted December 31, 2011 Nick, I had already read your post. It gave me a lot of confidence that I can remove/replace these knives with success. I'd been worried about that since I bought it. Thank you for posting. and you're right, the blades are still $21ish. The Freud knives get mixed reviews on Amazon, what's you're experience. the knives have done a fine job for me thus far. i have no complaints. they seem to be just about like the factory blades. now, i've only put maybe 10-15 board feet through them to date, so i wouldn't say they have had a workout yet. Quote
Onboard Posted December 31, 2011 Report Posted December 31, 2011 tdale, you might take a look at the Fine Woodworking article by Hendrik Varju in the current FW issue (#224). It’s shows how to put a micro-bevel on your jointer knives without removing the knives. If you don’t have access to that issue, and you have an online subscription to FW, you can read the article here. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.