Eric. Posted January 28, 2012 Report Posted January 28, 2012 Hey guys, I plan on enclosing my DC with a cabinet and maybe some closed-cell insulation to cut down on the decibals in the shop. Think it'll overheat? Bad idea? Alternative ideas? Thanks for any advice! Quote
tim0625 Posted January 29, 2012 Report Posted January 29, 2012 Motor has to breath or it will overheat. What provision are you making for the air that's collected to get out? Quote
Eric. Posted January 29, 2012 Author Report Posted January 29, 2012 It's gonna be vented directly outside. I'm thinking now I should probably just leave it open and deal with the noise, because you're right, running it for any extended period of time will certainly risk overheating. Quote
jsiard Posted January 29, 2012 Report Posted January 29, 2012 I wear hearing protection anytime I'm using power equipment so the noise from the dc is really a non-factor. Aside from that I think most of the other pieces are louder anyway, rarely will I use even a miter saw without a set of muffs. Quote
Eric. Posted January 29, 2012 Author Report Posted January 29, 2012 True, good point. Okay, forget that idea. Quote
tim0625 Posted January 29, 2012 Report Posted January 29, 2012 It's gonna be vented directly outside. I'm thinking now I should probably just leave it open and deal with the noise, because you're right, running it for any extended period of time will certainly risk overheating. Depending on how the air is leaving the cabinet.... you could cut a hole in the cabinet close to or under the DC motor and the natural action of air leaving will draw fresh air by the motor and you should be fine. I'm just not sure on your DC if the motor is down close to the base or up but the bottom hole could probably serve either. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.