cusas6 Posted February 25, 2012 Report Posted February 25, 2012 Hello All, This is my first post of this forum. I've read plenty of good things on here. So I thought I'd throw a question out there. I searched and didn't find this topic already posted. Here is the situation that I am in. I found a really good deal on aTracksaw from ToolBarn.com. It was the Dewalt with both the 102" and 56" tracks for $525. So needless to say I ordered it. On the site it said ships in 2-3 days. Well that was almost 3 weeks ago now. I called after about a week and was told it was on order from Dewalt and that they'd have it on that Friday. So I call after Friday and they told me that it would be 30-45 days out before they got one and I should just cancel the order. I would have, except it seems noone has that Dewalt kit. So my question is: On either the Dewalt or the Festool, when you put two shorter tracks together with the extension it is still perfectly straight? Or should I wait for kit with the long one. It seems like the connectors on both kits are less than a foot long so does that truely keep them in line. I am by no means a professional, but I only like to spend money once. I'm considering cancelling my existing order and going to Rockler and getting the Festool, but I can't see dropping $300 on the long track if I'm eventually need it. I look forward to hearing everyones comments. Regards, Scott Quote
Kevmc Posted February 25, 2012 Report Posted February 25, 2012 I have the festool and before I got a long rail I regularly connected two shorter rails. I never had a problem with the two rails joined together so long as I was careful when joining them and double checking as I tightened the connector screws Quote
Morton Posted February 25, 2012 Report Posted February 25, 2012 The festool rails should join together very straight. Put the two rails end-to-end, but leave about a 1/16" between them. They are each perfectly straight but not guaranteed to be exactly 90* at the ends, so leave a very small gap. Then use your track saw to bridge the gap and tighten the cams on the rail (so you can't move the saw). That means that the rails are now inline with each other. Now tighten down the connectors. I don't have two rails or connectors, but that's the method that was shown to me at the Festool training. I forget if one of the connectors was tightened first, then the above, then the other connector - i.e. the details - but I did remember to leave the gap and have the saw bridge it in order to connect rails inline with each other. I saved up and bought a larger rail and boy am I glad I did. It's so useful in a variety of situations. Of course it sucks that it was $300 - but it's awesome Quote
Mike M Posted February 25, 2012 Report Posted February 25, 2012 I have the Dewalt with the two tracks (45" and 54" I think). I haven't had a problem joining them to get an 8' cut. Unlike Morton's comments, the Dewalt tracks rely on the ends being square to align the tracks. There is only one joiner and its purpose is to hold the tracks together, not keep them straight. When connecting the tracks I don't leave any gap between them. Mike Quote
williaty Posted February 25, 2012 Report Posted February 25, 2012 I join a 1400mm and 1900mm rail for cutting plywood. It's quite easy to do if you're willing to be careful. Align it as best possible, tighten the connectors, and use the draw/flip/compare method to ensure that you have a perfectly straight edge. So far, it's worked perfectly every time. I'd have to be cutting long rips every day before I'd prefer the expense and storage hassle of a 3000mm rail over this method. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.