Dowel&Dovetail Posted April 26, 2012 Report Posted April 26, 2012 I have a new cabinet saw that I am setting up in my basement woodshop. Unfortunately my concrete basement floor is rather uneven. I am thinking of using shims under the saw cabinet and then securing the cabinet to the floor. I had been taking woodworking courses at a local adult school and the tablesaw there was secured with a section of steel angle bolted to the cabinet saw body and also bolted into the concrete floor. I was hoping to get some opinions as to how I should properly level and secure the saw so that it does not move or rock. Does anyone have any experience with this? I appreciate your input. Thanks, Matt Quote
dwacker Posted April 26, 2012 Report Posted April 26, 2012 What kind of saw do you have? There is no reason to bolt it to the floor. Leveling depends on the saw and type of cabinet. Don Quote
Dowel&Dovetail Posted April 26, 2012 Author Report Posted April 26, 2012 It's a Jet XACTA SAW Deluxe. Quote
dwacker Posted April 26, 2012 Report Posted April 26, 2012 It's a Jet XACTA SAW Deluxe. I had the 12" version of that one for years. I just used those plastic shims from lowes. Cut them off so you dont kick or trip on them. Put the saw in place and it will not move, wait until its shimmed before adjusting the tables the cabinets on non cast iron bases flex. Don Quote
Dowel&Dovetail Posted May 2, 2012 Author Report Posted May 2, 2012 Thanks for your input. I will get it fully assembled and then level with the shims per your guidance. Thanks again for the advice. -Matt Quote
TimV Posted May 2, 2012 Report Posted May 2, 2012 I have mine shimmed and not bolted to the concrete floor. It doesn't move. Of course, I've never run into it with a fork truck either Quote
Eric. Posted May 5, 2012 Report Posted May 5, 2012 Another vote on the shims...cabinet saw ain't goin' nowhere unless you really push on it. I built an outfeed table on top of a big cabinet and bolted the whole thing to the outfeed rail on the table saw. The two units together probably weigh half a ton by now and I bet it wouldn't budge even if I did run into it with Tim's fork truck. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.