Recommended Posts

Posted

I am planning on moving my jointer to be on the left side of my tablesaw (left if I were standing in front of the saw making a cut.)

I am sure someone else out there has done this. How much of a pain was it? I don't think it will be too bad because this will free up enough space to build a full 4' outfeed table.

Posted

I have mine on the right side where is doesn't interfere with any cuts, unless the highest point of the jointer was lower than the table of my saw I would not want it on the left side. I do like it on the side of my saw since it only sticks out a small amount past the saw and outfeed table so it effectively takes up less room in the shop.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   2 Members, 0 Anonymous, 50 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined