Recommended Posts

Posted

need help setting up my hand planes.. i have a block plane and a jack plane. both were just sharpened but would like some tips, tricks, and recommendations on how to get them properly tuned up

Posted

please don't take this as snarky, but how do they work now? If they work then you're good to go. Are you having problems getting them to cut now? Also recognize that the set up can vary depending on how you want to use them. If the Jack is meant for rough work then there is not set up other than probably cambering the iron. If you want to smooth with the Jack then a little more finesse is needed like a flat sole, close chip breaker, and tight mouth. The block doesn't need much fiddling and since end grain is where it excels, a tight mouth, VERY sharp blade, and fine cut is key. Where do you want to start?

Posted (edited)

excellent video! I will give it a try!

RWW, to answer your questions... they are not consistent.

I will try to setup via the videos steps and then report back!

Edited by Pbmaster11

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   3 Members, 0 Anonymous, 58 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined