Recommended Posts

Posted

Not entirely sure if this should go here, but oh well.

I've just got my self a nice big tail vise. My jaw is a ~1.75" thick piece of maple 18.75" long by about 9.75" wide. The metal part is pretty small, 10" long and 2.25" at its widest (around the threaded rod). My jaw is held to it by 3 lag screws with ~6.75" going above the metal. I've noticed that if I put something in the top that the bottom goes in quite a bit more and tilts the whole jaw. This means whatever I put in isn't held very well. Is there a good way to fix this? Should I even try to fix this?

Posted

Okay, the Maple jaw is far too tall for the vise - too much material above the metal face of the vise. As a result, it's racking. I would remove at least 3 inches off the top so it looks closer to this (below), which will necessitate moving the entire tailvise up along your apron to keep the jaw flush with the top of your bench. If you could post an image of your tailvise, that would also help in diagnosing the problem.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   3 Members, 0 Anonymous, 58 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined