rmconlon Posted October 1, 2012 Report Posted October 1, 2012 I have a DeWalt 616 plunge router that I also mount to my shop-made router table. I don't have the router on a lift or anything, so the bit change procedure is a bit tedious. I am considering the Eliminator RC Quick Change Chuck (http://www.amazon.com/QCC-DW2-Eliminator-Change-DeWalt-Routers/dp/B000W3K35C/ref=wl_it_dp_o_pC_S_nC?ie=UTF8&colid=3FBU8IB82YHSB&coliid=I21T044KC3BV4G) Does anyone out there have any first hand experience or anything good/bad to say about this product?? Quote
wdwerker Posted October 1, 2012 Report Posted October 1, 2012 Be aware that it increases the bit height and so reduces the amount of travel( vertical adjustment ). It will also increase the load on the bearings and add to lash/ vibration. They have some convenience but I would not use one on a large diameter bit! I had a different model ages ago and quit using it. Quote
wdwerker Posted October 1, 2012 Report Posted October 1, 2012 Did you see Whiteside has a version as well? Costs less and appears to have less height. Quote
Hybrid-woodworker Posted October 1, 2012 Report Posted October 1, 2012 I have one also and stopped using it do to increased vibration. I am sure that they can be used in special circumstances but full time I think would shorten the life of your router. BRuce Quote
rmconlon Posted October 2, 2012 Author Report Posted October 2, 2012 Thanks everyone for the quick replies. I had concerns about bit height and vibration, so I think I am going to pass on this chuck for now. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.