Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Problem streaks using GF clear Gel Topcoat

Featured Replies

So, trying a new (to me) product on a tabletop. I have the wood all sanded, cleaned, applied Danish oil for the first time. Turned out very nice, will probably use the Danish oil again.

Now I’m putting the topcoat on. Using General Finishes satin Gel Topcoat (first time using this). Put the first coat on a piece of scrap cutoff from the finished table. According to directions, put on a generous layer, then wiped off the excess to leave just a bit of a wet look. Turned out perfect, so I figured this will be great after 3 or 4 coats on the real piece.

So, as is sometimes the case I overthought myself and when applying the first coat Sunday on the actual tabletop left too much on after wiping the excess off. Result was streaks (thin high spots the length of the table) on parts of it. Just too much to level correctly, I guess. Sigh.

last night, I sanded most of it back off trying to get the streaks out and applied the second coat. There are still a few slightly shinier ‘trails’ left that show up in the right lighting.

On to my question for anyone who has used this product and possibly made the same lame mistake I just did. Do you think those couple streaks will disappear with subsequent layers, or do I have to go all the way down to bare wood and start over? The streaks I’m talking about are the darker, shinier trails in the picture.

picture http://www.flickr.com/photos/dtrust/8181133204/in/photostream

Try rubbing the streaks out with one of those plastic abrasive pads. I woul start with a red one then even the entire surface out with a gray pad. The first thing that caught my eye was the cross grain bands of different colors, is that a plywood top?

  • Author

Steve,

No, no plywood. It's made of Makore. 3 boards edge joined. The middle board was quite a bit different grain orientation than the other two, but the wifey liked the contrast. It's not actually my favorite combination, but I'll live with it to make her happy.

Don

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,009 Total Members
  • 3,644 Most Online
  • Joseph b Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.