RJsumthn Posted December 27, 2012 Report Posted December 27, 2012 I got my first air compressor today. It is a small 1.5 hp, 8 gallon, 125 Max PSI unit. I got a little kit with some fitting a blow gun and a small hose. The hose is 1/4" diameter and I was wondering if I should get a 3/8" hose. I also a Dewalt 18 gauge Brad nailer. I was testing it out on some 2x4's and I had to put the depth adjustment to the maximum depth to get the nail to sit below the surface. Is that normal? I was using the recommended pressure. Could it be the 1/4" hose? Thanks guys. Oh and any advice for air compressor and nail gun use would be appreciated because I am a total noob with this stuff. Quote
Freddie Posted December 27, 2012 Report Posted December 27, 2012 RJ, most pneumatic fastners run from 70-120 psi. 90 psi is the normal setting for your compressor. 1/4" is sufficient. You will see 3/8" normally on higher volume compressors or with a higher scfm(recovery rate). The reduction of 1/4" to ur brad nailer is more than adequate. Quote
pghmyn Posted December 27, 2012 Report Posted December 27, 2012 My compressor has a 3/8" hose, and it's plenty powerful. This doesn't mean you should get one because I have never had a 1/4" hose to compare it to. But, I have never had a problem with it, if that helps. Quote
Dlhunter Posted December 28, 2012 Report Posted December 28, 2012 The only hose I own are all 1/4". I use it for everything even my framing gun. You can try cranking up the pressure but I would guess its in the depth setting of the gun. My brad gun will shoot at lower psi and still sink the nail until pressure starts getting below 70psi. I just leave the compressor at 110. Are you using the no mar tip? Try taking it off and see how the gun shoots without it. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.