The other Matt Posted January 21, 2013 Report Posted January 21, 2013 I have been using a later model (1980s-era) Stanley standard-angle block plane and think that it will soon be time to upgrade. I am looking at Veritas and Lie-Nielsen models, but am not sure whether to go with low-angle or standard-angle. I have never used a low-anlge plane, but I know that the low-angle is supposed to give better results on end grain. Other than that, are there other significant differences between the two angle options? Thanks, Matt Quote
CessnaPilotBarry Posted January 21, 2013 Report Posted January 21, 2013 I have several examples of both block plane type. The low angle versions are excellent on end grain, and the versions I use most. I'll use the standard block when chamfering edge and face grain where a low angle tears out, and as a tiny smoother. I'd buy a low angle block. In rare occasions when the low angle isn't working, I'd either go back to the old plane, or swap the iron on the new one to a high angle. Don't abandon the Stanley, though... I have a 1990's Craftsman block plane that I think I paid $20 for, brand new, complete with plastic knobs and a coarse, backlash-filled, adjustment mechanism. It doesn't have anything, feel, heft, or edge retention-wise, on a premium block plane, but it still works just fine in lots of situations where I'd use a standard block. Quote
The other Matt Posted January 21, 2013 Author Report Posted January 21, 2013 Thank you. Good information. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.