Recommended Posts

Posted

I am in the process of designing a router table top that will be a part of my table saw workstation. AKA it will be on the right side as an extension wing. While I would love to have a cast iron deal, its out of the budget. I intend to use t-nuts embedded into the top. The fence will be L shaped with the rear portion of the angle that lays on the table slotted. This will allow me to use some star knobs to lock the fence to the table.

 

Has anyone else done this?

Pros and cons?

I also intend to apply laminate over the top, so the holes will have to be uncovered after the laminate dries to the top.

 

Thanks.

Posted

I would save my self the trouble and just build a fence that either attaches or slips over my TS fence.  Rockler has those clamps for holding sacrificial fences on that you could use to attach any type of router fence you would like.  The other thing you can do is use a T-slot track routed into the top after your laminate it.  

Also have you ever laminated anything?  The contact cement needs to be dry before you apply the laminate then as soon as the laminate gets stuck and rolled out it is good to go.  Hope this helps

  • Like 1
Posted

I would save my self the trouble and just build a fence that either attaches or slips over my TS fence.  Rockler has those clamps for holding sacrificial fences on that you could use to attach any type of router fence you would like.  The other thing you can do is use a T-slot track routed into the top after your laminate it.  

Also have you ever laminated anything?  The contact cement needs to be dry before you apply the laminate then as soon as the laminate gets stuck and rolled out it is good to go.  Hope this helps

 

I had thought of using the ts fence, but wasn't sure if I would ever run into the situation of needing to leave the ts fence set up during a project.

 

The t-track is a good idea.

Thanks :-)

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   2 Members, 0 Anonymous, 56 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined