Andrew Pritchard Posted September 23, 2013 Report Posted September 23, 2013 I was looking at some antique molding planes on line. They look from the pictures like they need some cleaning up, but it occurred to me that I have no idea how I'd sharpen the blades. So question for the floor, given that molding plane blades aren't flat - how do you sharpen the shaped blades? Do you need specific stones etc? Quote
TerryMcK Posted September 23, 2013 Report Posted September 23, 2013 Not easily but you would use shaped slip stones or even small diamond needle files. I have these http://www.flinn-garlick-saws.co.uk/acatalog/Clifton_Spokeshaves.html spokeshaves and hone them with a rounded slip stone. Here are a few http://www.axminster.co.uk/sun-tiger-traditional-shaped-water-slip-stones-prod23399/ Same principle with moulding planes. Quote
Popular Post Tom King Posted September 23, 2013 Popular Post Report Posted September 23, 2013 For the shapes, I use whatever I can find, like drill bit shanks, or wooden shapes, and diamond lapping film from Lee Valley or sometimes simply wet-or-dry sandpaper. Flattening the back will often get one plenty sharp to use, and the shapes just need a little touch up. The metal is typically pretty soft, but takes a nice sharp edge easily. I probably have over a hundred of them. Not many weeks go by that I don't get one or two off ebay. Just yesterday I found one I've been looking for more than a year. All the ones I've bought have been useable. Don't get one with a rusty iron. I have a good supply of Boxwood, so I don't mind replacing some of that. Typically mine have cost less than 20 bucks a piece. I paid a few dollars more for the one I bought yesterday only because I'd been looking for it for so long. It matches the profile of some windows I'm working on. http://www.ebay.com/itm/Good-5-16-ovolo-moulding-plane-by-Edward-Preston-Birmingham-/350875948694?_trksid=p2047675.l2557&ssPageName=STRK%3AMEWNX%3AIT&nma=true&si=GUuFltvwz7UAtaNiaFWOthHV9IQ%253D&orig_cvip=true&rt=nc I wouldn't buy ones that came out of a barn with cracked wood to amount to anything, nor a rusty iron. Hollows and rounds are very handy to have. New ones go for $250 each. Mine averaged about 15 bucks a piece and I use them just fine. 3 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.