pghmyn Posted September 26, 2013 Report Posted September 26, 2013 Set a limit for anniversary gifts for my fiancé and I. I didn't want us to spend more than $25 on each other. So I looked around for something I needed and came about the Rockler Wheel Gauge for about $20. http://www.rockler.com/m/product.cfm?page=21921&utm_source=google&utm_medium=cpc&utm_term=&utm_content=pla&utm_campaign=PLA&gclid=CNq-nben6bkCFSpk7AodzUQACA Anyone have any experience with this item? I can't imagine it is too hard to mis-manufacture this item. Although, I could be wrong. How is Rockler with returns? Just wondering incase of the worst case scenario. Quote
mds2 Posted September 26, 2013 Report Posted September 26, 2013 I have that gauge and really dont care for it much. The markings are only in 1/8" increments which isnt enough. I also find it kind of hard to set it accurately, micro adjustment would be a great improvement. Also, the screw that holds the cutting wheel sticks out past the end of the wheel, so you can use it to measure any sort of depth. The wheel itself isnt that sharp either. Quote
Llama Posted September 27, 2013 Report Posted September 27, 2013 I have the Veritas with micro adjustment and I love it. I don't think it is much more than the $25 or so dollars the Rockler one is. I have no use for the markings on the shaft, so the lack of more of them wouldn't bother me either way Quote
pghmyn Posted September 27, 2013 Author Report Posted September 27, 2013 I have the Veritas with micro adjustment and I love it. I don't think it is much more than the $25 or so dollars the Rockler one is. I have no use for the markings on the shaft, so the lack of more of them wouldn't bother me either way I was looking at the Veritas models, and they are very appealing. $40 for the non graduated micro adjustable. I think the graduations are kind of unnecessary because the thickness of my wood is never a set thickness. I almost never go right to 3/4" if I don't have to. I buy the stock rough, at a full 1"+ thick, and most of the time I can keep it at 7/8" thick when dressed. If I was to use the wheel gauge, it would be referenced from a stock piece and not a known measurement. Although, for an extra $3, just to get the graduated markings, it's not that big of a difference. I just think the micro adjust would be a really good feature. Looks like I will bide my time and eventually get the Veritas 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.