Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Sanding tiny burned-out corners?

Featured Replies

I am making a few oak pen boxes, mostly on a small routing table, and I'm getting some burned out areas on the end grain.  I've tried going at these with small sanding blocks and curled up sand pape, but haven't made any apparent progress.  

 

I'm not sure if the burn is deep or the wood is just that hard, but it takes quite a bit of effort to get through.  I have had a little luck with a chisel but that only works for the straight inset edge, and it doesn't work great.

  1. Is there anything I should do in the future to avoid burning the grain (might be the wood - the boxes I'm making in ash don't have this burning)?
  2. How do I sand out this box?  

I'm pretty new at a lot of this, so don't hesitate to recommend the 'obvious' stuff.  Thanks!

 

IMG_20140104_192516_102.jpg

  • Popular Post

Try making two passes...the first to hog out the bulk of the material, then raise the bit just a hair and make a second pass to remove the burning from the first pass.  Make the second pass quickly and don't leave the workpiece idle on the bit at any time.  Otherwise, put on some music, get out a jar of elbow grease, practice patience, and sand, sand, sand.

Agree with Eric - Sanding can be a PITA that's for sure!

Make sure your bit is clean ! Any built up resin can add to the burning.

If you have to sand start kinda coarse and work thru the grits. Each grit leaves scratches and the finer grits remove the coarser scratches.

like Steve said, check the bit for pitch, and also check to see how sharp the bit is. Usually you get more burning at the bit starts to get dull.

End-grain, not much you can do about that. It happens :). SAND/SAND/SAND

 

+1 what Eric said about a light final pass. The burn won't be as deep, but it can still burn, just not as bad. 

 

-Ace-

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,009 Total Members
  • 3,644 Most Online
  • Joseph b Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.