daviddoria Posted January 6, 2014 Report Posted January 6, 2014 I've seen jigs like this to plane short stock: http://www.woodworkingtips.com/etips/2006/05/26/wb/ However, I'm not sure I understand how they work. The thought is that the sled will be grabbed by first the roller on the infeed side, and then the roller on the outfeed side simultaneously - the lack of doing so is the problem with planing the short stock by itself in the first place. However, do the rollers really have that much vertical travel? That is, say the sled is 3/4" thick and the workpieces are 4/4" thick. Will the rollers grab the 3/4" sled while the planer is setup to cut an inch above what the rollers have grabbed (the top of the workpieces)? That is, when I set the planer depth (the thickness of the resulting piece) to 1 3/4" , I would expect the rollers to grab something maybe 1 1/4" - 1 1/2" or so (just an uneducated guess), but grabbing something at 3/4" seems like an awfully big descrepancy in depth - I would expect that the sled could just be pushed though the planer without ever contacting the rollers. Any comments on the validity of this technique? Is it a reasonable/safe thing to do? Thanks! David Quote
Eric. Posted January 6, 2014 Report Posted January 6, 2014 The rollers won't grab the sled...it just allows extra length so you can push the pieces in without getting your fingers so close to the cutterhead, and also so those small pieces will safely go through without getting kicked sideways and blown to bits. I've used this kind of sled before and they work...the biggest problem is snipe, since I'm assuming your pieces are so short because they're already at final dimension. Drum sander is the best tool for this job. Second best is a hand plane. Planer is the last resort. Don't stand behind the planer when you send them through. Quote
krtwood Posted January 6, 2014 Report Posted January 6, 2014 The cleat should be at the front of the sled, not the back. Quote
daviddoria Posted January 7, 2014 Author Report Posted January 7, 2014 @krtwood - why's that? Isn't the cleat to stop the workpieces from being ejected back at the operator when they start to be cut by the knives? Quote
krtwood Posted January 7, 2014 Report Posted January 7, 2014 If you do it without the double stick tape and the cleat at the back you'll see what happens is the infeed roller grabs the stock and launches it off the sled, which doesn't go anywhere. If the tape fails you need a cleat at the front to keep the sled moving along with the stock. Quote
dwacker Posted January 7, 2014 Report Posted January 7, 2014 @krtwood - why's that? Isn't the cleat to stop the workpieces from being ejected back at the operator when they start to be cut by the knives? Krtwood is correct that the cleat really should be used as a safety for the tape but it is really to push the wood in this poorly designed jig. First thing I would say is just forget it altogether. The jig is designed keep the pieces from slipping sideways and exploding like Eric stated. That being said the sled should not move it should have a cleat on the underside of the infeed. The sled should be long going from one side of the planer to the other. The holding strips should be fixed to the sled and the stock is fed between the two strips. Go look at the bed of a moulder or pictures and you will get the point this is all you are trying to acomplish. Williams-Hussey-209-Molder.jpg Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.