Pwalter5110 Posted March 8, 2014 Report Posted March 8, 2014 I am installed a whole house humidifier on my furnace. All of the low voltage wires are installed, I'm just not sure how to go about wiring the transformer to the 110 circuit to complete the installation. I have a Trane XR95 furnace, and aprilaire 400 with digital display humidifier. Thanks in advance. Quote
Tpt life Posted March 8, 2014 Report Posted March 8, 2014 What is your question? Most new furnace installs have a junction box with a shutoff right on the outside of the unit. You can easily grab power there. Quote
Tpt life Posted March 8, 2014 Report Posted March 8, 2014 Buy a 4 x 4 deep box or get an extension ring. Then you can enclose the transformer with lots of space around it. If they tell you it needs to be open to air you may need to open some of the side knockouts. Quote
Pwalter5110 Posted March 8, 2014 Author Report Posted March 8, 2014 Well I read on some furnaces it isnt needed. You could just install wires to the furnace board that produce 24v and bypass the transformer. Also, is it alright to have the furnace and humidifier on one breaker? Quote
Tpt life Posted March 8, 2014 Report Posted March 8, 2014 Those questions will need to come from an HVAC tech but consider this, if you can pull power from the furnace then you are still using the same circuit. Quote
Pwalter5110 Posted March 8, 2014 Author Report Posted March 8, 2014 Yea. Thats what i'm not sure about. And i wasnt sure if the transformer got mounted internally in the furnace or close to the outlets on the outside. Quote
Tpt life Posted March 8, 2014 Report Posted March 8, 2014 Ok, the more I chew on this, if you do not wire to the thermostat then you really ought to pull from the furnace. You want to operate the device while the furnace is operating if you mount it in a duct. Quote
Pwalter5110 Posted March 9, 2014 Author Report Posted March 9, 2014 Yea. Thermostats run off of 24v. I have all of the inputs to the humistat ran, and they all are working. There is a valve that turns the water on and off to the humidor that also runs off of 24v, but it goes to the transformer, which is powered by 110v. I decided to run it off the furnace electrical outlet. But the water valve isn't working, and I don't have 24v coming out of the transformer. I think I either messed up the transformer messing around with it, or it came bad…unless I wired it backwards. But I put black to black and white to white. The wiring diagram doesn't show anything and SUCKS! Quote
Tpt life Posted March 9, 2014 Report Posted March 9, 2014 Give this a gander and see if any of your furnace resembles this install. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.