dwacker Posted November 5, 2014 Report Posted November 5, 2014 Do a search for MTMwood the guy is a cutting board wizard. Take a look at how he flattens then. Quote
Jfitz Posted November 5, 2014 Report Posted November 5, 2014 Do a search for MTMwood the guy is a cutting board wizard. Take a look at how he flattens then. I've seen some of his work - ridiculously amazing. Quote
Jfitz Posted November 5, 2014 Report Posted November 5, 2014 Says something about my skill level. Thanks for the warning. Check out this article http://www.thewoodwhisperer.com/articles/end-grain-through-the-planer/ Quote
chefmagnus@grics.net Posted November 8, 2014 Report Posted November 8, 2014 I have been using a home built jig to use a PC belt sander with a 24g belt to flatten boards. It holds the sander perpendicular to the travel of the board under it. I have to take three or four passes to get each board flat. It works better than just using the belt sander because it keeps everything flat. I am making a batch that I am going to try making flat with a router jig. I don't have my drum sander yet. Quote
Adam Rahberg Posted December 29, 2014 Report Posted December 29, 2014 I just started with 60 grit with my ROS and went up to 180 Boards look great. On the other hand, Austin Hardwoods in Denver will rent out their 54" belt sander for $40 per half hour and will go from 36 grit to 120 grit. I Have used that for a number of table top glue ups. I also have some air dried 3.5" thick slabs of American Elm that I need to take down considerably. I'll be going there as they are 27" wide and I won't be doing them by hand. Cabinet shops were a waste of time as the "our insurance won't allow it" is an excuse for, "why would we waste time on you"? Try the hardwood suppliers that sell your rough stock as well as millwork and such. Austin is a GREAT place and they have contractor pricing if you are in the denver area. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.