Fxguy Posted September 16, 2015 Report Posted September 16, 2015 I've got my hands on a new to me Grizzly 1019z 14" bandsaw that uses a 98" blade. The blade that came with it isn't exactly sharp so I'm looking to replace it. Lots of choices in terms of blade with and teeth per inch. Is there a general chart for something like this that helps select a blade depending on what you're doing? (i.e. resawing vs cutting curves) Thanks! Quote
Guest Posted September 16, 2015 Report Posted September 16, 2015 Taunton (fine woodworking) has a book on bandsaws written by Roland Johnson. it contains blade recommendations and a whole lot more useful information. I just follow the recommendations in the book. unlike a tables aw where there are only a couple of blade configurations you need, bandsaw blades come in way too many configurations for me to commit to memory. Quote
Eric. Posted September 16, 2015 Report Posted September 16, 2015 A 3/8" 4TPI will be the most versatile blade for that saw if that's the only saw you have. It can do bigger curves, rips and resaw. It's like the jack plane of bandsaw blades. For tighter curves you'll want a skinnier blade. If you want a smoother cut you'll need higher TPI. I keep low TPI blades on both my saws since no bandsawn surface is glue or finish ready...I don't care how many teeth a blade has. You'll have to do work to the surface after the cut regardless...so you may as well cut fast. Quote
Tom Cancelleri Posted September 16, 2015 Report Posted September 16, 2015 I will say check out the Starrett blades, I recently put one on my Laguna 1412 and I've been very happy with it's performance. They are fairly cheap in comparison with most other blades. Quote
Tom King Posted September 16, 2015 Report Posted September 16, 2015 (edited) It's hard to get by with just one blade. Timberwolf blades are good for the money. Edited September 16, 2015 by Tom King Quote
Fxguy Posted September 16, 2015 Author Report Posted September 16, 2015 Thanks guys! I did finally get a chance to check out some guides as far as the teeth per inch (new baby in the house). I knew that the smaller radius requires a smaller blade width, but wasn't exactly sure about the teeth per inch. I was thinking of getting a 4 and a 10-14 to have on hand to start with. Any opinions on the Timberwolf blades? How much tolerance is there in blade length? Does it have to be exactly 98 inches or will 98.5 inches work? Quote
Tom King Posted September 16, 2015 Report Posted September 16, 2015 I meant to say Timberwolf, but remembered the name Woodslicer incorrectly. I just came back to change that. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.