miranthis Posted December 15, 2015 Report Posted December 15, 2015 (edited) Background:Ok, I dusted off my A-Line it kit and went to work to get some data on my TS. It is a Craftsman 113.29902 (emerson I believe), built in 1967 and has been in family since then. It was used in the late 60's through 72 or 3 by my Grandad to make few dozen projects. It sat in his garage until about 1997 when I got it. I have made pretty good use of it, but really got more serious iun the last couple years about woodworking as opposed to outdoor or rough projects. I usually use a 10 inch Diablo thin kerf 60 tooth crosscut blade. I also have a Diablo 24 tooth rip blade and an assortment of old Kromedge HSS blades that came with it. I have added a zero clearance insert, the link belt and such over the years. Last addition was the PALS and I found out that the PALS nuts interfere with the tilt travel of the saw near 45 degrees (it's a left tilt) and I need to modify the rip fence bracket to eliminate that. For the moment I am doing the tilt measurements at 37 degrees. The data on the saw is below, my question is, what to do with it, the data that is.. No, I am not wanting, nor getting a new saw, as I like this one. :-)Measurements:Blade run out, using the A-Line It is 0.0035 in. with most of that in one quadrant of the blade (never been damaged that I am aware of). The run out on the arbor face and the arbor shaft is less than 0.001 each. Measuring front to back on the alignment I see that at 90 degrees the REAR is +0.0045 and at a 37 degree tilt it is +0.0035 at the FRONT. I also noticed that the tilt lock lever needs to be fully engaged or else the measurements change.The difference between the alignment from 90 degrees to 37 degrees is additive (it is + one way and - the other) at 0.0080. So, I assume that I need to fix the tilt alignment first with shims and then reassess the 90 degree error. if I can get both of those within 0.002 or thereabouts I think i am doing well...and there is the rub - the run out of the blade is 0.0035. FWIW, i tried to do the alignment measurements on one of the other 3 quadrants of the blade.Question:1) What to do, if anything?2) Where to start if I am doing something.3) Is that Diablo blade trashed with that run out?4) Have I missed something? Jeff in KC Edited December 15, 2015 by miranthis Quote
sjeff70 Posted December 19, 2015 Report Posted December 19, 2015 I almost bought a 113 Emerson a few weeks ago but he wanted $275. I researched around for upgrades on this saw because when I finally do get one I want to be ready. I've read where people have had problems beveling their blades using those PALS. It seems the best option is to just loosen all trunnion bolts, leaving one in a front corner snug, while tapping the rear trunnion until the blade is parallel to the miter slot. I don't think aligning to a .001 is necessary but others can chime in on this one. I'm interested in what others have to say but I'll be surprised if anyone here has one of these saws. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.