Janello Posted April 26, 2016 Report Share Posted April 26, 2016 Also, in the future if you're dead set against the look of stiles and rails, like a short coffee table apron, you could pattern route them using nice strait 1/4 mdf stuck down with turners tape as a template. Then you just have a little bit of corner chiseling to do. My approach would be to block the piece up and clamp it mdf side down and use a hand held router clockwise with a bottom bearing flush trim bit. Quote Link to comment Share on other sites More sharing options...
shaneymack Posted April 26, 2016 Report Share Posted April 26, 2016 Really moving quickly on this project, Paul. Good progress! Sent from my SM-N910W8 using Tapatalk Quote Link to comment Share on other sites More sharing options...
Rex Edgar Posted May 2, 2016 Report Share Posted May 2, 2016 By now this probably should be in the 'Project Showcase' thread, but here are a few before oil and after first coat. Hard to see in the photos, but the top to bottom tapers at 2 1/2 degrees. Ting oil is the finish. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.