Popular Post mrrhode04 Posted November 18, 2016 Author Popular Post Report Share Posted November 18, 2016 Well I know this is a old thread but I got the little table top thing done and installed, makes everything look nice. Also no need for the crowd funding anymore the dish washer has been replaced. 3 Quote Link to comment Share on other sites More sharing options...
estesbubba Posted November 18, 2016 Report Share Posted November 18, 2016 Looks great! Have any pics of how you did the corner? Quote Link to comment Share on other sites More sharing options...
mrrhode04 Posted November 18, 2016 Author Report Share Posted November 18, 2016 Thank you. The corner is a standard miter joint and I used two Tite joint fasteners to pull it together. http://www.rockler.com/tite-joint-fastener Quote Link to comment Share on other sites More sharing options...
wdwerker Posted November 18, 2016 Report Share Posted November 18, 2016 Either buy the jig & bit or have a good dowel jig and careful layout of the intersecting holes to use those Tite Joint Fasteners. I've used them for years. If the little rod to tighten them is lost or bends use a tape wrapped drill bit shank. Making a practice joint is a very smart idea ! This can prevent a mistake on the actual countertop. Drilling the large hole too deep and coming through the good face is a nightmare, trust me ,been there done that (didn't want the tee shirt ) 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.