Rex Edgar Posted January 2, 2017 Report Posted January 2, 2017 I'm getting lazy and old..... I have a KREG router table with many of the KREG upgrades, table top, fence, table rails, casters, remote power switch. I am thinking of getting a lift for the router as it is becoming more of a hassle to adjust the height of the cutter. What are the option available and does the router need to be replaced? Presently the router is an older MAKITA 3 1/4 HP. The other question deals with dove tail dados. I have launched a few pieces of stock off the table and want to get my procedure down. If I am correct a sliding dovetail cut cannot be done but in one pass. You can't start with a little cut and then add a little more height. What is the proper method, especially if the wood is dense. Just feed very slowly or is there something I am missing? Quote
Popular Post 21meyer Posted January 2, 2017 Popular Post Report Posted January 2, 2017 1 hour ago, Rex Edgar said: The other question deals with dove tail dados. I have launched a few pieces of stock off the table and want to get my procedure down. If I am correct a sliding dovetail cut cannot be done but in one pass. You can't start with a little cut and then add a little more height. What is the proper method, especially if the wood is dense. Just feed very slowly or is there something I am missing? I usually hog out the bulk of the material with a straight bit in a couple passes and then switch to the dovetail bit. The straight bit obviously needs to be smaller in diameter than your dovetail bit. 3 Quote
gee-dub Posted January 3, 2017 Report Posted January 3, 2017 I do as Mike does. Lift makers generally have lists of routers that will fit their carriage. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.