Recommended Posts

Posted

Here is the blade guard on my Hammer K3 (it is usually set higher than in the photo below) ..

Blade-guard1.jpg

Parts ...

Blade-guard2.jpg

At the rear of the guard is a pin that acts as a stop (it can just be made out in the second photo). The problem is that the guard does not lift up and extend to offer visibility when lining up a cut. How do you deal with this? Modify/remove the rear pin?

Regards from Perth

Derek

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.