Recommended Posts

Posted

Good morning all. I have just moved up from a dewalt job site saw to a sawstop contractor saw.  When I set it up do I align the blade and fence to just one of the miter tracks? I seam to get different readings from each track. Also I am using the woodpeckers dial indicator.

When I check the blade to the left miter track and measure from just behind the tooth on the face and slide the dial indicator  to the back without rotating the blade 180 degrees  it reads less than a thousands  off.  If I mark a carbide zero the dial out on the tooth itself and rotate to the same tooth in the back I'm between 8 and 10 thousands  off. Just kind of lost here thank you for any suggestions.     Joe

Posted

If I understand correctly you are taking measurements off of the carbide portion of the saw blade. Don't measure from that standpoint the saw blades are simply not made with that level of Tolerance in mind. Instead measure from below the teeth and only the center portion of the saw blade so for instance a 10in saw blade the actual measurable portion is probably about 8 inches wide. But since you can never actually get the full width of the saw blade because the arbor is in the way your actual measurable distance on most saws is going to be around 6 inches. This is the portion that you care about. If you're still getting wildly different readings from one miter slot to the next I would check other saw blades first before assuming there is a problem with your miter slots.

Posted

Great. Then I should be less than a thouslanths off. I am using a new forrest ww2 think kerf so there may be some deflection also. I will check again tonight with a second blade also. Ty for your help!

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   3 Members, 0 Anonymous, 33 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined