Hammer5573 Posted August 19, 2019 Report Posted August 19, 2019 I have a Kreg lift mounted in my router table and I am very pleased with the design and accuracy; however, the fine threads on the vertical adjustment screw get gummed up with fine sawdust. This requires periodic removal and cleaning. Does anyone have any suggestions about how to prevent this..? Quote
gee-dub Posted August 20, 2019 Report Posted August 20, 2019 What are you using for dust collection? Is there good travel for the spoil? I only run a 2HP cyclone with a 4" lower collection port and the threads stay pretty clean on my Woodpecker PRL. I use a little CRC 3-36 as a lube and really don't need to clean out the threads. A bit of spoil does collect but, they are never a movement issue. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.