Popular Post collinb Posted November 22, 2024 Popular Post Report Posted November 22, 2024 This is my only Lie plane. Perfect for trimming the hardwood edging (abandoned the iron-on for this home project). this and the Record 060 1/2 worked best for their low angle and small size. When time allows I’m going to keep doing this. the key to good hardwood edging are … 1 cut to consistent thickness 2 no glue squeeze out. As best as possible 3 clamp evenly to avoid gap shadow lines 4 precision plane for evening the edges. (The Lie did a better job than the Record when it came to dealing with the removal of what minimum squeeze out did occur) Will post project pics when it’s done next week. 3 Quote
wtnhighlander Posted November 22, 2024 Report Posted November 22, 2024 @collinb, for your edging, did you glue on a plain flat strip, or did you add any sort of "joint" profile to assist with alignment and add glue surface? I've seen folks use a V-cut or a slot in the panel edge, with a mating shape on the edging, and wondered how much it helps. Especially after struggling to get a flat strip glued on evenly and held firmly while it dried... Quote
Popular Post collinb Posted November 22, 2024 Author Popular Post Report Posted November 22, 2024 On 11/21/2024 at 11:19 PM, wtnhighlander said: @collinb, for your edging, did you glue on a plain flat strip, or did you add any sort of "joint" profile to assist with alignment and add glue surface? I've seen folks use a V-cut or a slot in the panel edge, with a mating shape on the edging, and wondered how much it helps. Especially after struggling to get a flat strip glued on evenly and held firmly while it dried... On 11/21/2024 at 11:19 PM, wtnhighlander said: @collinb, for your edging, did you glue on a plain flat strip, or did you add any sort of "joint" profile to assist with alignment and add glue surface? I've seen folks use a V-cut or a slot in the panel edge, with a mating shape on the edging, and wondered how much it helps. Especially after struggling to get a flat strip glued on evenly and held firmly while it dried... I started the process by cutting a bunch of same thickness strips of the cherry. If I hadn’t done that, the results would look pretty inconsistent. before cutting the cherry, though, I cleaned the blade so that I could cut quickly and avoid burn. I’m very happy I did that. The method I found online was to cut a strip slightly larger than what was needed. That only made sense. Exact fit leaves too much room for error. On some of the practice pieces I tried using the trim router to square it up. I found that to be good but not exactly what I wanted. I ended up using the Lie plane to get it even more precise trim than the router would give. When it came to the glue, one of the important points in the article I read was to have zero squeeze out. at first I wasn’t very successful with that. The best method, per the article, was to put it very, very thin on both pieces and then clamp them with a board under the clamp to spread out the pressure. That gave me the most consistent edge. The Lie plane is tunable to such a fine degree that I could use it to remove the minimal squeeze out without scarring the wood. Hence those nice little ribbons in the picture. In the end I didn’t use any jig for alignment. What I would do is align one side of the edge piece with one side of the board. No sense in doing trim work that I don’t have to do. Clamping went a little slower that way as I had to deal with the piece floating, as always happens with glue up. Does that answer your question? I rambled a bit. 3 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.