Recommended Posts

Posted

Greetings,

I am making some 1 1/4" thick edge grain cutting boards from Maple. These boards are shaped like States and are cut with a band saw and routed using a flush trim bit and a pattern. Currently I use a 1/4" spiral flush trim bit because of the detail required. This has been a real challenge. Since the grain direction is always changing, including going from edge grain to crossing end grain the bit sometimes grabs and wants to break out chunks of the board. I am sure there is a proper process for doing this. I would like any suggestion anyone has for completing this process including the correct tools, speeds and procedures.

Thanks

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 40 Guests (See full list)

  • Forum Statistics

    32k
    Total Topics
    437.5k
    Total Posts
  • Member Statistics

    26,007
    Total Members
    3,644
    Most Online
    FurniCore
    Newest Member
    FurniCore
    Joined