Beechwood Chip Posted May 28, 2025 Report Posted May 28, 2025 I want to route some dados in the sides of an existing cabinet to add some shelves. I'd use an edge guide from the top of the cabinet side (the top has been removed). Is this an unsafe operation? Anything I should be aware of? Quote
Popular Post gee-dub Posted May 28, 2025 Popular Post Report Posted May 28, 2025 Just proper feed direction I believe. As I've gotten older and lost some strength I prefer to have the router captured as opposed to edge-guided. Not necessary for those who still have good upper body and arm strength. 3 Quote
Mark J Posted May 28, 2025 Report Posted May 28, 2025 A smaller router might be best for the job. What are you planning to use? Quote
Von Posted May 28, 2025 Report Posted May 28, 2025 Seems like I've seen drywallers do similar cuts frequently to make openings. Granted that's in drywall and not wood. I'd use a palm router and start with a shallow pass to get an understanding of what I'm doing and the forces involved. 1 Quote
Popular Post Beechwood Chip Posted May 28, 2025 Author Popular Post Report Posted May 28, 2025 Unfortunately my trim router needs a new collet, so I was going to use my PC 690 with a fixed base. My brain just realized that this is way too much hassle and I can just use shelf pins instead. Grooves for sliding shelves was my first thought, but when it came to actually making them it just got more and more convoluted. The vertical edge guide was the third solution after my first two attempts failed. As I was writing, I just thought, "It's too bad there's not a guide to cut identically spaced grooves like there is for drilling holes for shelf pins." And then I realized, "Wait, why not just use shelf pins? It's not ideal for sliding the shelves in and out, but it's a lot better than all this craziness." I think I'll use three columns of shelf pins, to make it easier to remove and replace the shelves. 3 Quote
Von Posted May 28, 2025 Report Posted May 28, 2025 I don't see a fundamental issue, just more of an upper body work out. Quote
Mark J Posted May 28, 2025 Report Posted May 28, 2025 3 hours ago, Beechwood Chip said: think I'll use three columns of shelf pins, to make it easier to remove and replace the shelves. Or, if you want continuous support, you could make two shelf pin holes on each side. Then using two dowels glue in a rail for your sliding shelf. 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.