Beechwood Chip Posted June 22 Report Posted June 22 I'm trying to use a dovetail router bit with a bushing. The opening in the bushing is too small for the dovetail cutter to fit through. So, I need to put the base with the bushing on the router motor, then put the bit through the bushing into the collet. But when I do that, it is nearly impossible to tighten the collet through the tiny opening in the base. I'm using a BOSCH 1617EVSPK 2.25 HP with the fixed base. The height adjustment rod is in the way. This is my first time using a bushing. I must be doing something wrong. 1 Quote
Coop Posted June 22 Report Posted June 22 Chip, just out of curiosity, why are you using a bushing? Quote
Beechwood Chip Posted June 22 Author Report Posted June 22 On 6/21/2026 at 10:38 PM, Coop said: Chip, just out of curiosity, why are you using a bushing? I'm trying out a fancy new dovetail jig. Quote
gee-dub Posted June 22 Report Posted June 22 The outer bushing diameter rides the jig fingers. There is a relationship between the bushing diameter and the bit geometry. This should all be defined in the jig manual. It can seem overly involved at first but once you get your head around it things will move along. The problem you describe tells me you do not have the right pieces for this operation. Re-check the manual and make sure you have the correct components. 2 Quote
Popular Post Von Posted June 22 Popular Post Report Posted June 22 It seems odd to me to have a set up that would require a bushing of smaller diameter than the bit such that you are so restricted on the height of the bit. My guess is that if you were to get the bit tightened, your next problem would be the bit being extended too far and not being able to retract it enough. 3 Quote
Popular Post Beechwood Chip Posted June 22 Author Popular Post Report Posted June 22 Figured it out. In addition to using this dovetail jig and bit for the first time, it was also the first time using the fixed base with my Bosch router. The base has a clear plastic window on one side, and I guess you're supposed to pop that out to change bits. It pops in and out easily. I just assumed that it was meant to be permanent. Thank everyone for the help! 6 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.