baok Posted September 24, 2011 Report Posted September 24, 2011 I've been wondering. When you use a piece of leather charged with the green honing compound, you eventually end up with a build up of dark material. Presumably that is a mixture of metal particles from the stropped tools and whatever waxy stuff from the honing compound. Do you ever need to scrape that stuff off the strop or can it just build up indefinitely? Quote
lwllms Posted September 25, 2011 Report Posted September 25, 2011 I've never removed it, just occasionally recharge the face with fresh compound. I use two strops, one with green compound and one with Yellow Stone compound, and don't see a lot of difference between the two compounds. Yellow Stone is supposed to cut faster but there's just not much difference. I only take a couple swipes to remove remnants of a wire edge and avoid much stropping because it will dub an edge. For this reason, I don't think a lot of stropping between honing is a good idea. Quote
Jonathryn Posted September 25, 2011 Report Posted September 25, 2011 I've heard the black stuff is actually the carbon from the high carbon steel. I put a little mineral oil in and rub it around. Stropping works for me--it keeps an edge shipshape. If you're concerned about dubbing an edge against leather, you can also rub the CrO2 on something harder, like the flat side of masonite. Barbers will strop a straight razor two or three times on the palm of their hand. Quote
HoboMonk Posted September 26, 2011 Report Posted September 26, 2011 I occasionally clean and dress my leather with a little Neatsfoot Oil, then I sing that 1960's pop song: Strop! In The Name Of Love... Quote
jHop Posted September 26, 2011 Report Posted September 26, 2011 I've never met anybody who cleaned their strop aside from knocking the worst buildup off with the back of their finger. Usually, the application of whatever you use to strop with (other than the leather) seems to be enough to clear the worst off. then again, you aren't going to be stropping for a long time. If you take more than 5 strokes (I've been told), you shouldn't be stropping, you should still be sharpening. Quote
Mark Reuten Posted November 10, 2011 Report Posted November 10, 2011 I occasionally give mine a scrape down if the build up appears to be uneven or if I can see too many particles in the compound. I figure small fragments of wire edge get trapped in the soft compound and can undermine your goal of a really clean edge. I also give the strop a few drops of oil once in a while. Been doing all this for 20 years on the same strop. No ill effects. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.