Recommended Posts

Posted

I probably shouldn't tell this.

Last night I was trying to flatten a wide piece of walnut with a Stanley #7 jointer. Normally I only use it to edge joint so this was a new experience for me but I had been watching Schwarz's video on handplanes and so was inspired.

I noticed that it was only cutting on the two edges and not in the middle.

I didn't even know that was possible.

The last time I ground it, I took it to a friend who has a Tormek and obviously did not pay attention to the details. Anyway, I spent some time on my bench stones and now it's actually straight across its width and works as it should.

Posted

Your friend probably spent too much time on the middle of the blade and not enough on the sides with the Tormek. That would lead to removing more metal from the middle of the blade, which is why your blade is cutting at the corners. That's an easy thing to overlook with any sort of grinding wheel.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.