baok Posted January 9, 2012 Report Posted January 9, 2012 Why do most modern grinders have that V-shaped groove in one of the tool rests? That thing is preventing me from using the tool rest for much of anything over on that side. Quote
Jim Heinbuch Posted January 9, 2012 Report Posted January 9, 2012 I don't know the "official" answer but my guess is that is serves as a rest for round objects, i.e. a shaft, so that it will stay in place and be square to the wheel. Quote
CessnaPilotBarry Posted January 9, 2012 Report Posted January 9, 2012 I'll go with Jim... Attach a piece of 1/4" MDF to the rest with carpet tape. No more groove! Quote
Jim Heinbuch Posted January 9, 2012 Report Posted January 9, 2012 Good idea Barry, 1/8" hardboard might work too. Quote
lwllms Posted January 9, 2012 Report Posted January 9, 2012 The groove is for sharpening standard twist drill bits. Quote
jmk89 Posted January 9, 2012 Report Posted January 9, 2012 I find the standard tool rests for grinders to be more of a hindrance than a help and have replaced them with the very simple design that Robert Wearing shows in his book of Aids and Appliances. Here is a post that I put up in my blog on the Woodworking Forums (Australia) about this: Wearing Grinder rest Quote
baok Posted January 10, 2012 Author Report Posted January 10, 2012 I should have thought of this before: I have a nephew who is a machinist. I emailed him and he says it's for round things to keep them from jumping around as you deburr an edge like after you cut with a hacksaw. Apparently the People who buy grinders for home use do that a lot. - will design rockets for food Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.