kyleheon Posted February 22, 2012 Report Posted February 22, 2012 I noticed last weekend when cutting some panels that my cuts were off by as much as an 1/8 of an inch front to back (smaller in the back). I've been trying since Monday evening to calibrate the fence with my A-Line-It Deluxe Kit but I can't seem to find the right combination to get front/back in line. My question though is, what is an acceptable difference and in what direction should that difference be (wider in front or back)? Quote
Sac Posted February 22, 2012 Report Posted February 22, 2012 Ideally you are going to want it within a few thousandths. I think that i have mine setup to where it is about .002 out at the end. This gives just a little bit of room for the board to go through. It also avoids any pinching that may occur. Some people run it straight, others, like me, leave it open just a little. One thing to remember is that the blade need to be aligned to the miter slot as well. Quote
kyleheon Posted February 22, 2012 Author Report Posted February 22, 2012 Thanks for the info. I'm starting to think I cannot get this fence perfectly calibrated and might just need a new one. I had it within two thousands of an inch but then I moved the fence and tested again and it was about 5 hundreds out. That is basically what I've been dealing with all week. I inherited this table saw from my grandfather, from my estimation this is a 1999 Grizzly 1022. Quote
kyleheon Posted February 22, 2012 Author Report Posted February 22, 2012 I'm thinking this fence will be a worth while upgrade. Quote
Sac Posted February 23, 2012 Report Posted February 23, 2012 I would say that that fence would be a MAJOR improvement. Quote
kyleheon Posted February 29, 2012 Author Report Posted February 29, 2012 I order that fence last night, should be in tomorrow. I managed to get to within .002 (out) but once I moved the fence and retightened it was way off again (in by .08). Quote
over40pirate Posted March 2, 2012 Report Posted March 2, 2012 I'm sure you will like the T2 fence. Be sure to align the blade to miter slot, before aligning te fence. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.