Recommended Posts

Posted

I'd like to clean and finish the iron top of my table saw. it has some marks and scratches in it that'd i'd love to smooth out... though, they're all the way to the left and probably not a big deal.

I'd also like to clean off any glue or other residue left behind from the previous owner and then wax it. but, i don't know where to start.

Posted

Start with a straight razor blade. It will remove a surprisingly amount of junk and rust too. Then switch to a scotch-brite pad. And finish with wax. I use Johnson's Paste Wax on my cast iron surfaces. Don't worry about the scratches, they won't affect anything unless there is a burr that is sticking up.

  • Like 1
Posted

Start with a straight razor blade. It will remove a surprisingly amount of junk and rust too. Then switch to a scotch-brite pad. And finish with wax. I use Johnson's Paste Wax on my cast iron surfaces. Don't worry about the scratches, they won't affect anything unless there is a burr that is sticking up.

Agreed. Good advice here.

Posted

+1 on the Johnson's, first time I used it I had trouble lining up my cross cut with the miter gauge, just kept sliding to far. Now if I can't get it lined up I just have to put a little on and its easy. Huge can for the price too.

  • 5 weeks later...
Posted

I use paste wax on my table tops too. Just make sure its pure carnuba and doesn't have a silicones in it. The silicone might transfer to the wood you are cutting and give you problems when finishing.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.