JohnnyNoName Posted April 25, 2012 Report Posted April 25, 2012 I had a small accident in the shop today. Nothing serious. I was cross-cutting some small pieces with my mitre gauge on my tablesaw. On one of the cuts I didn't quite push the piece far enough pass the blade. It rattled, caught the back of the blade, and was thrown at me. It hit me in my upper arm, and then ricocheted back and hit my check. I have a 4/4 bruise on my bicep and a small scrape on my cheek. I had a backing board on the mitre saw, a splitter, and the fence was removed. I had on my safety glasses, dust mask, and hearing protection. I think a riving knife might have stopped the accident from occurring, but most likely it would have still happened. Working with power tools is like an animal trainer working with a Bengal tiger. The trainer might be in control of the relationship, but the tiger will remind the trainer every once in a while that if the trainer isn't paying attention, the tiger will bite his face off. Be safe, Jonathan ============================================= Quote
pagel Posted April 25, 2012 Report Posted April 25, 2012 Working with power tools is like an animal trainer working with a Bengal tiger. The trainer might be in control of the relationship, but the tiger will remind the trainer every once in a while that if the trainer isn't paying attention, the tiger will bite his face off. Great analogy, Jonathan. Quote
PeteJr Posted April 25, 2012 Report Posted April 25, 2012 Jonathan, Were you at all concerned about the safety of the cut before you pushed the work into the blade? The reason I ask is that I believe cutting small pieces on the table saw is prone to kickback. Pete Quote
rodger. Posted April 25, 2012 Report Posted April 25, 2012 Thanks for the reminder. Your comparison is a good one. Quote
JohnnyNoName Posted April 25, 2012 Author Report Posted April 25, 2012 Jonathan, Were you at all concerned about the safety of the cut before you pushed the work into the blade? The reason I ask is that I believe cutting small pieces on the table saw is prone to kickback. Pete Pete - I was concerned. I new to push the piece all the way through and pass the blade. I was cutting 15 pieces. This was about the fifith one I cut. I just stopped short, with the piece literally just past the blade, it traveled from the vibration of the saw and got to the blade. It's a good thing that I was to the side of the saw, and not in line with the blade. Jonathan ========================== Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.