Eric. Posted May 21, 2012 Report Posted May 21, 2012 I agree about the stopped dados...and that's why I usually do use the router for those. But in reality it's no more dangerous than making stopped grooves in smaller pieces on the router table...you do that don't you? Quote
jmaichel Posted May 21, 2012 Report Posted May 21, 2012 So James, I guess the answer to my question would be..."about halfway?" Neener-neener. Fair enough It's not the perfect solution, a little time consuming but I don't have a router or table saw. Whats really nice is that Lee Valley now offers a variety of sizes for the Veritas Router Plane which makes cleaning out dados and rabbets of different sizes a little easier. Quote
williaty Posted May 21, 2012 Report Posted May 21, 2012 I agree about the stopped dados...and that's why I usually do use the router for those. But in reality it's no more dangerous than making stopped grooves in smaller pieces on the router table...you do that don't you? I rarely use the router table for dados at all. I tend to do all of it with the track. With the work secured to the MFT and then the rail secured to either the work or the MFT, plunging the router down into the work gives me a whole lot less of a wiggins than trying to drop a little piece of wood onto a spinning bit. I tend to use the table more if I'm making a rabbet than for an actual dado. Sometimes I will use the table for a through-dado, but only if the dado is pretty close to the edge of the work and the work is pretty stick-like. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.