Recommended Posts

Posted

I just purchased a delta jointer off of CL.

When I run boards across the blades it takes material off the front part of the board and slowly decreases till about half way on the board. No matter how many passes, no matter what material.

Is it the blade setup? not co-planar?

Posted

Could be either or both. Check the outfeed table, make sure it is not drooping, and check to make sure the knives are at the same height as the outfeed table.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 43 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined