baok Posted September 20, 2012 Report Posted September 20, 2012 Why are shoulder planes so expensive? I don't think I've ever seen one (at least one that wasn't of questionable ancestry) for less than $150 and often twice that. Quote
JayWC Posted September 20, 2012 Report Posted September 20, 2012 You can get a Stanley #92 for around $90. I have one and it works just fine. Having said that, I had to go through the stock of the store to find one that was milled correctly. The Rockler store I went to sent what I called rejects back for exchange too because they were that bad. Still, I'd recommend it for typical use, decent price and decent ancestry. Quote
ChrisG Posted September 20, 2012 Report Posted September 20, 2012 There's a lot of precise maching on a shoulder plane. Not just the sole but sides as well. The sides need to be both flat and square and the bed has to be square to the sides. If the bed is off on a shoulder plane you can't just use the lateral adjuster to move the blade becaue the side of the blade will then stick out the side and get in the way of the cut. The bed is also very long so its likley that it requires more machining then the bed of a bench plane. More areas of machining also means more areas that need to have flawless casting... basically there are probably more reject castings with shoulder planes. Long story short, my assumption is that the price reflects higher toleances/machinging costs/time and labor costs. Of course, I don't really know what goes into making a should plane, but that's my best guess. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.