duckkisser Posted September 29, 2012 Report Posted September 29, 2012 hey i have a set of flex chip knives and it seems that no matter how often i sharpen them they dont cut the wood as easily as when i first got them. im wondering if i dont sharpen them enough . when you are carving wood how aften do you sharpen your knives? when ever i sit down to carve I run it across the stone 10 times on each side. should i change that to 20 times, 40? i run it across my nail and its sharp but still it seems like it does not slice as easily as the first couple of carving that i did. can i just strop them back and forth a few times ever few min? figured out that when i use them on the strop i am using them in the wrong direction is that a big factor in what im doing wrong? thought i was saposed to push the blade along the strop like you would a stone Quote
Mike M Posted September 29, 2012 Report Posted September 29, 2012 I sharpen my chip carving knives at a very shallow angle. Basically, I lay the knife on the stone then raise the back edge less than 1/16 inch. This gives me a thin edge that slides through the cut easily but doesn't stay sharp very long. I also use my strop (leather on wood board) to touch up the edge whenever it starts to drag. When using the strop, I drag the knife with the edge trailing a few times in each side. If you strop with the edge leading, the knife will tend to cut the strop. The leather will also flex slightly and come up over the edge, blunting it. Quote
duckkisser Posted September 29, 2012 Author Report Posted September 29, 2012 im thinking thats my problem mike im blunting it a bit. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.